Repairing Broken and Damaged Stone and Brick using Lithomex – FAQ by Randy Ruth

by Randy Ruth

Randy-doing-Lithomex

Of course following the Lithomex technical data sheet is important to ensure a quality application, but what about the little things that can’t fit on one sheet of paper?  The small details that help make good finish “POP” into a quality indistinguishable patch. There are many things that are far to subtitle to translate onto paper from experience and feel of mortar and trowel. So practice, timing and tools are critical overview subjects to be discussed here.

Practicing patching old single salmon bricks not in a wall is a cheap and technically challenging exercise. The porosity of salmon bricks demonstrates the importance of controlling suction. If suction is not controlled, bond failure can occur while detailing outside corners. It’s these corners that give rise to the technical challenge. By coating multiple sides of a brick, it helps create focus on multiple surface planes. The initial reshaping step doesn’t have to be perfect. It just has to have about 1/8 inch extra material beyond the desired finish. Once Lithomex is well bonded to three sides of a brick, wait for the material to stiffen to thumbprint hard.

DSC_0126Re-troweling the surface will compact the patch to compensate for any slight shrinkage. While using trowels, squares, straight edges, miter rods and improvised tools to shave back and cut away undesired material to the finished profile will create the rough finish. When finishing a masonry unit in a wall, long metal straight edges are great to use as a profiling tool. With the edges exposed over to adjacent units or edges, they act as a guide to bring the finish to proper plane. Typically much of this profiling can be done in the first day of patching; however 12-24 hours later more intricate detailing and carving can be done. Tooth chisels can be used during this time frame to scratch in tooth marks or crandled finishes.

photo-e1328884464676

As more time is allowed to let the patch “firm up” stone masons chisels can be used in a traditional method to give more authentic characteristics. Sanders and rubbing block are also useful for honing the surface to a more polished or pristine finish.

Following these tips and practicing will build upon previous experiences for the craftsman or aspiring novice, facilitating a better rounded approach to brick, stone and terracotta patching.

Other Examples in Use:

 



Presented by LimeWorks.us

Phone: 245-536-6706

LimeWorks.us (FaceBook : Google+ : LinkedIn : Twitter : YouTube)