This beautiful late 19th century Hummelstown brownstone was recently restored by deGruchy Masonry Restoration, the Technical Install/Training Team of LimeWorks.us. Using historically appropriate, breathable Natural Hydraulic Lime based materials for repointing the brickwork and repairing the brownstone, this iconic building is now put into an excellent state of conservation. It remains a testament to excellent stewardship of our built heritage thanks to the owner, and lifelong resident of Middletown, PA, Robin Pellegrini.
Taking an architectural conservator’s approach, the team of masons repaired the broken and missing pieces of historic sandstone and lime mortar with environmentally friendly Ecologic® Mortar and Lithomex Brick and Stone repair material. The team retained as much of the historic fabric as possible by repairing what could be salvaged with these specialty materials. These materials allow the building envelope to process water out naturally through the lime and sandstone because of their effective liquid/vapor transfer properties over any patch material based on Portland cement.
Please take a look at our other videos for the full extent of this remarkable restoration:
Of course following the Lithomex technical data sheet is important to ensure a quality application, but what about the little things that can’t fit on one sheet of paper? The small details that help make good finish “POP” into a quality indistinguishable patch. There are many things that are far to subtitle to translate onto paper from experience and feel of mortar and trowel. So practice, timing and tools are critical overview subjects to be discussed here.
Practicing patching old single salmon bricks not in a wall is a cheap and technically challenging exercise. The porosity of salmon bricks demonstrates the importance of controlling suction. If suction is not controlled, bond failure can occur while detailing outside corners. It’s these corners that give rise to the technical challenge. By coating multiple sides of a brick, it helps create focus on multiple surface planes. The initial reshaping step doesn’t have to be perfect. It just has to have about 1/8 inch extra material beyond the desired finish. Once Lithomex is well bonded to three sides of a brick, wait for the material to stiffen to thumbprint hard.
Re-troweling the surface will compact the patch to compensate for any slight shrinkage. While using trowels, squares, straight edges, miter rods and improvised tools to shave back and cut away undesired material to the finished profile will create the rough finish. When finishing a masonry unit in a wall, long metal straight edges are great to use as a profiling tool. With the edges exposed over to adjacent units or edges, they act as a guide to bring the finish to proper plane. Typically much of this profiling can be done in the first day of patching; however 12-24 hours later more intricate detailing and carving can be done. Tooth chisels can be used during this time frame to scratch in tooth marks or crandled finishes.
As more time is allowed to let the patch “firm up” stone masons chisels can be used in a traditional method to give more authentic characteristics. Sanders and rubbing block are also useful for honing the surface to a more polished or pristine finish.
Following these tips and practicing will build upon previous experiences for the craftsman or aspiring novice, facilitating a better rounded approach to brick, stone and terracotta patching.
Bricks can hollow back quite profusely in some cases. What are some of the causes?
Don’t forget vermin. Accelerated wetting and drying cycles near the bottom of the brick building cause an increase in the decay of the soft bricks. However, where there is water and calcium rich lime mortar there can be ants and bugs nesting in and behind the wythe. Masonry Bees are found in some parts of the country and will burrow. Sparrows and Starlings will take the calcium bits from lime mortar and like a cuttle bone use the grains for digestion. Some very deep holes in the brickwork are from wood peckers who sense the presence of the bugs and they hone in on certain areas in an attempt to get to them. Here’s one example that may have been caused by a combination of water and animals.